Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 774
description, flow-based enable
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 774 highlights
www.dell.com | support.dell.com • On the S-Series, one monitor session can have only one MG port. There is no restriction on the number of source ports, or destination ports on the chassis. Note: The monitoring port should not be a part of any other configuration. description c e s Enter a description of this monitoring session Syntax description {description} To remove the description, use the no description {description} command. Parameters description Enter a description regarding this session(80 characters maximum). Defaults No default behavior or values Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.7.1.0 Version 7.5.1.0 pre-7.7.1.0 Introduced on S60 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Related Commands monitor session Enable a monitoring session. flow-based enable e Enable flow-based monitoring. Syntax flow-based enable To disable flow-based monitoring, use the no flow-based enable command. Defaults Disabled, that is flow-based monitoring is not applied Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 8.1.1.0 Version 7.4.1.0 Introduced on E-Series ExaScale Introduced on E-Series Usage To monitoring traffic with particular flows ingressing/egressing the interface, appropriate ACLs can be Information applied in both ingress and egress direction. Related Commands monitor session Create a monitoring session. 774 | Port Monitoring