Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 942

www.dell.com | support.dell.com Version 7.5.1.0 pre-Version 6.1.1.0 Introduced for C-Series Introduced for E-Series Usage Information If you want to log in without being prompted for a password, log in through RSA authentication. To do that, you must first add the SSHv2 RSA public keys to the list of authorized keys. This command adds the specified RSA keys to the following file: flash://ADMIN_DIR/ssh/authorized-keys-username (where username is the user associated with this terminal). Note: The no form of this command deletes the file flash://ADMIN_DIR/ssh/ authorized-keys-username Related Commands show ip ssh rsa-authentication ip ssh rsa-authentication (Config) Display RSA authorized keys. Enable RSA authentication. ip ssh server c e s Configure an SSH server. Syntax ip ssh server {enable | port port-number} [version {1 | 2}] To disable SSH server functions, enter no ip ssh server enable command. Parameters enable port port-number [version {1 | 2}] Enter the key word enable to start the SSH server. (OPTIONAL) Enter the keyword port followed by the port number of the listening port of the SSH server. Range: 1 to 65535 Default: 22 (OPTIONAL) Enter the keyword version followed by the SSH version 1 or 2 to specify only SSHv1 or SSHv2. Defaults Default listening port is 22 Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S60 Introduced for S-Series Expanded to include specifying SSHv1 or SSHv2; Introduced for C-Series Introduced for E-Series Usage This command enables the SSH server and begins listening on a port. If a port is not specified, listening Information is on SSH default port 22. Example Figure 36-9. ip ssh server port Command Example Force10# conf Force10(conf)# ip ssh server port 45 Force10(conf)# ip ssh server enable Force10# 942 | Security