Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 26
boot config
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
www.dell.com | support.dell.com • show file • show file-systems • show linecard • show os-version • show running-config • show startup-config • show version • upgrade (E-Series version) • upgrade (C-Series version) • upgrade (S-Series management unit) on page 57 • upgrade fpga-image (E-Series) boot config ce Set the location and name of the configuration file that is loaded at system start-up (or reload) instead of the default startup-configuration. Syntax boot config {remote-first | rpm0 file-url | rpm1 file-url} To return to the default setting, enter no boot config {remote-first | rpm0 | rpm1}. Parameters remote-first rpm0 rpm1 file-url Enter the keywords remote-first to attempt to load the boot configuration files from a remote location. Enter the keywords rpm0 first to specify the local boot configuration file for RPM 0. Enter the keywords rpm1 first to specify the local boot configuration file for RPM 1. Enter the location information: • For a file on the internal Flash, enter flash:// followed by the filename. • For a file on the external Flash, enter slot0:// followed by the filename. Defaults Not configured. Command Modes CONFIGURATION Command History Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage To display these changes in the show bootvar command output, you must save the running Information configuration to the startup configuration (copy running-config startup-config or write). Dell Force10 strongly recommends using local files for configuration (RPM0 or RPM1 flash or slot0). When you specify a file as the boot config file, it is listed in the boot variables (bootvar) as LOCAL CONFIG FILE. If you do not specify a boot config file, then the startup-configuration is used, although the bootvar shows LOCAL CONFIG FILE = variable does not exist. When you specify a boot config file, the switch reloads with that config file, rather than the startup-config. Note that if you specify a local config file which is not present in the specified location, then the startup-configuration is loaded. 26 | File Management