Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 1019
debug spanning-tree bpdu, description, disable, Command Modes, Command, History, Usage, Information
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1019 highlights
Command Modes EXEC Privilege Command History Version 8.3.3.1 Version 7.7.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S60 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage When you enable debug spanning-tree bpdu for multiple interfaces, the software only sends Information information on BPDUs for the last interface specified. Related Commands protocol spanning-tree Enter SPANNING TREE mode on the switch. description c e s Enter a description of the Spanning Tree Syntax Parameters description {description} To remove the description from the Spanning Tree, use the no description {description} command. description Enter a description to identify the Spanning Tree (80 characters maximum). Defaults Command Modes Command History No default behavior or values SPANNING TREE (The prompt is "config-stp".) Version 8.3.3.1 pre-7.7.1.0 Introduced on S60 Introduced Related Commands protocol spanning-tree Enter SPANNING TREE mode on the switch. disable c e s Disable Spanning Tree Protocol globally on the switch. Syntax disable To enable Spanning Tree Protocol, enter no disable. Defaults Enabled (that is, Spanning Tree Protocol is disabled.) Command Modes SPANNING TREE Command History Version 8.3.3.1 Version 7.7.1.0 Introduced on S60 Introduced on S-Series Spanning Tree Protocol (STP) | 1019