Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 919

debug radius c e s View RADIUS transactions to assist with troubleshooting. Syntax debug radius To disable debugging of RADIUS, enter no debug radius. Defaults Disabled. Command Modes EXEC Privilege Command History Version 8.3.3.1 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S60 Support added for S-Series Support added for C-Series Introduced on E-Series ip radius source-interface c e s Specify an interface's IP address as the source IP address for RADIUS connections. Syntax Parameters ip radius source-interface interface To delete a source interface, enter no ip radius source-interface. interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16838. • For the Null interface, enter the keywords null 0. • For the Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults Command Mode Command History Not configured. CONFIGURATION Version 8.3.3.1 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S60 Support added for S-Series Support added for C-Series Introduced on E-Series Security | 919