Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 302
neighbor soft-reconfiguration inbound, neighbor subnet
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
www.dell.com | support.dell.com Command History Version 8.3.3.1 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S60. Introduced support on S-Series Introduced support on C-Series neighbor soft-reconfiguration inbound c e s Enable soft-reconfiguration for BGP. Syntax neighbor {ip-address | peer-group-name} soft-reconfiguration inbound To disable, use the no neighbor {ip-address | peer-group-name} soft-reconfiguration inbound command. Parameters ip-address peer-group-name Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to disable or enable all routers within the peer group. Defaults Disabled Command Modes ROUTER BGP Usage This command enables soft-reconfiguration for the BGP neighbor specified. BGP will store all the Information updates received by the neighbor but will not reset the peer-session. Caution: Inbound update storage is a memory-intensive operation. The entire BGP update database from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor. Related Commands Command History Note: This command is supported in BGP Router Configuration mode for IPv4 Unicast address only. show ip bgp neighbors Display routes received by a neighbor Version 8.3.3.1 Version 7.8.1.0 Version 7.7.1.0 Version 7.4.1.0 Introduced on the S60. Introduced support on S-Series Introduced support on C-Series Introduced neighbor subnet c e s Enable passive peering so that the members of the peer group are dynamic Syntax neighbor peer-group-name subnet subnet-number mask To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask command. 302 | Border Gateway Protocol IPv4(BGPv4)