Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 825
queue ingress
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 825 highlights
queue ingress e Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast bandwidth queue. Syntax queue ingress multicast {linecard slot number port-set number | all} [wred-profile name] To return to the default, use the no queue ingress multicast {linecard slot number port-set number | all} [wred-profile name] command. Parameters linecard number port-set number all wred-profile name Enter the keyword linecard followed by the line card slot number. E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300. Enter the keyword port-set followed by the line card's port pipe. Range: 0 or 1 Enter the keyword all to apply to all line cards. (OPTIONAL) Enter the keyword wred-profile followed by your WRED profile name in character format (16 character maximum). Or use one of the pre-defined WRED profile names. Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g Defaults No default behavior or values Command Modes CONFIGURATION Command History Version 7.4.1.0 and 6.5.3.0 Introduced on E-Series Usage This command does not uniquely identify a queue, but rather identifies only a set of queues. The Information WRED Curve is applied to all eight ingress Multicast queues. Note: The multicast-bandwidth option is not supported on queue ingress. If you attempt to use the multicast-bandwidth option, the following reject error message is generated: % Error:Bandwidth-percent is not allowed for ingress multicast Related Commands show queue statistics ingress Display the ingress queue statistics Quality of Service (QoS) | 825