Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 714
ip ospf dead-interval, ip ospf hello-interval
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 714 highlights
www.dell.com | support.dell.com Related Commands When you configure OSPF over multiple vendors, use the ip ospf cost command to ensure that all routers use the same cost. Otherwise, OSPF routes improperly. auto-cost Control how the OSPF interface cost is calculated. ip ospf dead-interval c e s Set the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax ip ospf dead-interval seconds To return to the default values, enter no ip ospf dead-interval. Parameters seconds Enter the number of seconds for the interval. Range: 1 to 65535. Default: 40 seconds. Defaults 40 seconds Command Modes INTERFACE Command History Version 8.3.3.1 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S60 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage By default, the dead interval is four times the default hello-interval. Information Related Commands ip ospf hello-interval Set the time interval between hello packets. ip ospf hello-interval c e s Specify the time interval between the hello packets sent on the interface. Syntax ip ospf hello-interval seconds To return to the default value, enter no ip ospf hello-interval. Parameters seconds Enter a the number of second as the delay between hello packets. Range: 1 to 65535. Default: 10 seconds. Defaults 10 seconds Command Modes INTERFACE 714 | Open Shortest Path First (OSPFv2 and OSPFv3)