Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 678
multicast-buffering enable, queue backplane multicast
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 678 highlights
www.dell.com | support.dell.com As an Mtrace transit or intermediate router, FTOS returns the response to Mtrace queries. Upon receiving the Mtrace request, FTOS computes the RPF neighbor for the source, fills in the request and the forwards the request to the RPF neighbor. While computing the RPF neighbor, the static mroute and mBGP route is preferred over the unicast route. multicast-buffering enable Enable buffering for all multicast traffic on the buffering unit. Syntax [no] multicast-buffering enable Command Modes CONFIGURATION Command History Version 8.3.3.8 Introduced on S60. Usage Information Use this command to enable backpressure messages for multicast traffic and allow the system to start buffering multicast traffic. If multicast traffic is buffered for one group on any port, all multicast, Destination Lookup Failure (DLF) and broadcast traffic is buffered. Note that multicast packets might be dropped if either of the following occurs: • continuous oversubscription at the egress • if the packet is not drained for a long period because of slow draining rate at the egress port compared to high ingress rate. You must reboot the switch to enable the command on a standalone unit. Buffering multicast units is not supported on stacked units. Related Commands show hardware stack-unit Display the data plane or management plane input and output statistics of the designated component of the designated stack member. queue backplane multicast e Reallocate the amount of bandwidth dedicated to multicast traffic. Syntax queue backplane multicast bandwidth-percentage percentage Parameters percentage Enter the percentage of backplane bandwidth to be dedicated to multicast traffic. Range: 5-95 Defaults Command Modes Command History 80% of the scheduler weight is for unicast traffic and 20% is for multicast traffic by default. CONFIGURATION Version 7.7.1.0 Introduced on E-Series 678 | Multicast