Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 483

Related Commands interface show ip interface show interfaces show interfaces transceiver Configure a physical interface on the switch. Displays Layer 3 information about the interfaces. Display information on a specific physical interface or virtual interface. Display the physical status and operational status of an installed transceiver. The output also displays the transceiver's serial number. show interfaces transceiver ces Display the physical status and operational status of an installed transceiver. The output also displays the transceiver's serial number. Syntax show interfaces [gigabitethernet | tengigabitethernet] slot/port transceiver Parameters gigabitethernet tengigabitethernet For a 10/100/1000 interface, enter the keyword gigabitethernet followed by the slot/port information. For a 10G interface, enter the keyword tengigabitethernet followed by the slot/port information. Command Modes EXEC EXEC Privilege Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.5.4.0 Introduced on the S60. Introduced on E-Series ExaScale Output augmented with diagnostic data for pluggable media Removed three fields in output: Vendor Name, Vendor OUI, Vendor PN Introduced on C-Series and S-Series Introduced on E-Series Usage See the figure below for an example screenshot, and see the following table or a description of the output fields. For related commands, see the Related Commands section, below, and see the Debugging and Diagnostics chapter for your platform at the end of this book. Interfaces | 483