Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 868
output-delay, passive-interface
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 868 highlights
www.dell.com | support.dell.com output-delay c e s Set the interpacket delay of successive packets to the same neighbor. Syntax output-delay delay Parameters To return to the switch software defaults for interpacket delay, enter no output-delay. delay Specify a number of milliseconds as the delay interval. Range: 8 to 50. Default Command Modes Not configured. ROUTER RIP Command History Version 8.3.3.1 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S60 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage This command is intended for low-speed interfaces. Information passive-interface c e s Suppress routing updates on a specified interface. Syntax passive-interface interface To delete a passive interface, use the no passive-interface interface command. Parameters interface Enter the following information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 255 for TeraScale, 1-128 on C-Series and S-Series. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Command Modes Not configured. ROUTER RIP Command History Version 8.3.3.1 Version 7.8.1.0 Introduced on S60 Introduced on S-Series 868 | Router Information Protocol (RIP)