Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 97
show environment C-Series and E-Series, Command Example
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Example Figure 4-13. Command Example: show debugging Force10#show debug Generic IP: IP packet debugging is on for ManagementEthernet 0/0 Port-channel 1-2 Port-channel 5 GigabitEthernet 4/0-3,5-6,10-11,20 GigabitEthernet 5/0-1,5-6,10-11,15,17,19,21 ICMP packet debugging is on for GigabitEthernet 5/0,2,4,6,8,10,12,14,16 Force10# show environment (C-Series and E-Series) c e View the system component status (for example, temperature, voltage). Syntax show environment [all | fan | linecard | linecard-voltage | PEM | RPM | SFM] Parameters all fan linecard linecard-voltage PEM RPM SFM Enter the keyword all to view all components. Enter the keyword fan to view information on the fans. The output of this command is chassis dependent. See Figure 4-10, Figure 4-11, and Figure 4-12 for a comparison of output. Enter the keyword linecard to view only information on line cards Enter the keyword linecard-voltage to view line card voltage information. Enter the keyword pem to view only information on power entry modules. Enter the keyword rpm to view only information on RPMs. Enter the keyword sfm to view only information on SFMs. Note: This option is supported on E-Series only. Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.8.1.0 Added temperature information for C-Series fans Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage Information Fan speed is controlled by temperatures measured at the sensor located on the fan itself. The fan temperatures shown with this command may not accurately reflect the temperature and fan speed. Refer to your hardware installation guide for fan speed and temperature information. Control and Monitoring | 97