Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 522

www.dell.com | support.dell.com Table 16-2. Difference between Link MTU and IP MTU Layer 2 Overhead Ethernet (untagged) VLAN Tag Untagged Packet with VLAN-Stack Header Tagged Packet with VLAN-Stack Header Difference between Link MTU and IP MTU 18 bytes 22 bytes 22 bytes 26 bytes Related Commands mtu Set the link MTU for an Ethernet interface. ip name-server c e s Enter up to 6 IP addresses of name servers. The order you enter the addresses determines the order of their use. Syntax ip name-server ip-address [ip-address2...ip-address6] To remove a name server, use the no ip name-server ip-address command. Parameters ip-address ip-address2... ip-address6 Enter the IP address, in dotted decimal format, of the name server to be used. (OPTIONAL) Enter up five more IP addresses, in dotted decimal format, of name servers to be used. Separate the IP addresses with a space. Defaults No name servers are configured. Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S60. Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series Usage FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other Information interfaces, including the Management port. ip proxy-arp c e s Enable Proxy ARP on an interface. Syntax ip proxy-arp To disable Proxy ARP, enter no ip proxy-arp. Defaults Enabled. 522 | IPv4 Routing