Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 814
clear qos statistics, match ip access-group, E-Series Only Behavior
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 814 highlights
www.dell.com | support.dell.com clear qos statistics c e s Clears Matched Packets, Matched Bytes, and Dropped Packets. For TeraScale, clears Matched Packets, Matched Bytes, Queued Packets, Queued Bytes, and Dropped Packets. Syntax clear qos statistics interface-name. Parameters interface-name Enter one of the following keywords: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults No default behavior or values Command Modes EXEC EXEC Privilege Command History Version 8.3.3.1 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S60 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information Related Commands E-Series Only Behavior If a Policy QoS is applied on an interface when clear qos statistics is issued, it will clear the egress counters in show queue statistics and vice versa. This behavior is due to the values being read from the same hardware registers. The clear qos statistics command clears both the queued and matched byte and packet counters if the queued counters incremented based on classification of packets to the queues because of policy-based QoS. If the queued counters were incremented because of some other reason and do not reflect a matching QoS entry in CAM, then this command clears the matched byte and packet counters only. show qos statistics Display qos statistics. match ip access-group c e s Configure match criteria for a class map, based on the access control list (ACL). Syntax match ip access-group access-group-name [set-ip-dscp value] To remove ACL match criteria from a class map, enter no match ip access-group access-group-name [set-ip-dscp value] command. 814 | Quality of Service (QoS)