Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 474

www.dell.com | support.dell.com show interfaces dampening c e s Display interface dampening information. Syntax show interfaces dampening [[interface] [summary] [detail]] Parameters interface summary detail (Optional) Enter one of the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a port channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 • E-Series Range: 1 to 255 for TeraScale and ExaScale • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter the keyword summary to display the current summary of dampening data, including the number of interfaces configured and the number of interfaces suppressed, if any. (OPTIONAL) Enter the keyword detail to display detailed interface dampening data. Defaults No default values or behavior Command Modes EXEC Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on the S60. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Example Figure 15-32. show interfaces dampening Command Example Force10#show interfaces dampening Interface Supp Flaps Penalty State Gi 3/2 Up 0 0 Gi 3/10 Up 0 0 Force10# Half-Life 20 5 Reuse 800 750 Suppress 4500 2500 Max-Sup 120 20 Related Commands dampening show interfaces show interfaces configured Configure dampening on an interface Display information on a specific physical interface or virtual interface. Display any interface with a non-default configuration. 474 | Interfaces