Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 438
auto-mdix
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 438 highlights
www.dell.com | support.dell.com • lfs enable • link debounce-timer • monitor • mtu • negotiation auto • portmode hybrid • rate-interval • show config • show config (from INTERFACE RANGE mode) • show interfaces • show interfaces configured • show interfaces dampening • show interfaces description • show interfaces linecard • show interfaces phy • show interfaces stack-unit • show interfaces status • show interfaces switchport • show interfaces transceiver • show range • shutdown • speed (for 10/100/1000 interfaces) • speed (Management interface) • stack-unit module • switchport • wanport auto-mdix Enable Auto-MDIX on copper ports. Syntax [no] auto-mdix Defaults Enabled Command Modes INTERFACE Command History Version 8.3.5.3 Version 8.3.3.3 Introduced on the S55. Introduced on the S60. Usage Information With Auto-MDIX enabled, you can connect two network devices irrespective of the cable type (straight-through or crossover) and the MDI mode of the peer device. When Auto-MDIX is disabled at both ends, the copper ports behave as MDI. In this case, you need a crossover cable to connect the port to another MDI port, or a straight-through cable to connect the port to a MDIX port. The link will not come up when wrong cables are used. 438 | Interfaces