Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 744

www.dell.com | support.dell.com Syntax show ip ospf process-id neighbor Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Command Modes EXEC EXEC Privilege Command History Version 8.3.3.1 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S60 Introduced support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 26-15. Command Example: show ip ospf process-id neighbor Force10#show ip ospf 34 neighbor Neighbor ID Pri State Dead Time Address 20.20.20.7 1 FULL/DR 00:00:32 182.10.10.3 192.10.10.2 1 FULL/DR 00:00:37 192.10.10.2 20.20.20.1 1 FULL/DROTHER00:00:36 192.10.10.4 Force10# Interface Area Gi 0/0 0.0.0.2 Gi 0/1 0.0.0.1 Gi 0/1 0.0.0.1 Table 26-11. Command Example Descriptions: show ip ospf process-id neighbor Row Heading Neighbor ID Pri State Dead Time Address Interface Area Description Displays the neighbor router ID. Displays the priority assigned neighbor. Displays the OSPF state of the neighbor. Displays the expected time until FTOS declares the neighbor dead. Displays the IP address of the neighbor. Displays the interface type slot/port information. Displays the neighbor's area (process ID). show ip ospf routes c e s Display routes as calculated by OSPF and stored in OSPF RIB. Syntax show ip ospf process-id routes Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults Command Modes No default values or behavior EXEC 744 | Open Shortest Path First (OSPFv2 and OSPFv3)