Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 982
snmp-server view, snmp trap link-status
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 982 highlights
www.dell.com | support.dell.com Related Commands Note: The number of configurable users is limited to 16. show snmp user Display the information configured on each SNMP user name. snmp-server view c e s Configure an SNMPv3 view. Syntax snmp-server view view-name oid-tree {included | excluded} To remove an SNMPv3 view, use the no snmp-server view view-name oid-tree {included | excluded} command. Parameters view-name oid-tree included excluded Enter the name of the view (not to exceed 20 characters). Enter the OID sub tree for the view (not to exceed 20 characters). (OPTIONAL) Enter the keyword included to include the MIB family in the view. (OPTIONAL) Enter the keyword excluded to exclude the MIB family in the view. Defaults No default behavior or values Command Modes CONFIGURATION Command History Version 8.3.3.1 Introduced on S60 Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command Usage Information Example The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a sub-tree or a MIB. The following example configures a view named rview that allows access to all objects under 1.3.6.1: Figure 39-10. snmp-server view Command Example Force10# conf Force10#(conf) snmp-server view rview 1.3.6.1 included Related Commands show running-config snmp Display the SNMP running configuration snmp trap link-status c e s Enable the interface to send SNMP link traps, which indicate whether the interface is up or down. Syntax snmp trap link-status To disable sending link trap messages, enter no snmp trap link-status. 982 | SNMP and Syslog