Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 629

Example Figure 21-9. show mac cam Command Example Force10#show mac cam Slot Type MAC CAM Size MAC FIB Entries 0 E24PD 64K entries 48K (75%) 2 E24PD2 128K entries 64K (50%) 11 EX2YD 64K entries 16K (25%) Note: All CAM entries are per portpipe. Force10# MAC ACL Entries 8K (25%) 32K (50%) 24K (75%) Table 21-3. show mac cam Information Field Slot Type MAC CAM Size MAC FIB Entries MAC ACL Entries Description Lists the active line card slots. Lists the type of line card present in the slot. Displays the total CAM size available. Note: A portion of the MAC CAM is used for system operations, therefore adding the MAC FIB and MAC ACL will be less than the MAC CAM. Displays the amount and percentage of CAM available for MAC addresses. Displays the amount and percentage of CAM available for MAC ACLs. show mac learning-limit c e Display MAC address learning limits set for various interfaces. Syntax show mac learning-limit [violate-action] [detail] [interface interface [vlan vlan-id]] Parameters violate-action detail interface interface vlan vlan-id (OPTIONALY) Enter the keyword violate-action to display the MAC learning limit violation status. (OPTIONAL) Enter the keyword detail to display the MAC learning limit in detail. (OPTIONAL) Enter the keyword interface with the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For SONET interfaces, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a Port Channel ID between 1 and 255. On the E-Series, enter the keyword vlan followed by the VLAN ID. Range: 1-4094 Command Modes EXEC EXEC Privilege Layer 2 | 629