Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 304
neighbor update-source, neighbor weight
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
www.dell.com | support.dell.com Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series neighbor update-source c e s Enable the E-Series software to use Loopback interfaces for TCP connections for BGP sessions. Syntax neighbor {ip-address | peer-group-name} update-source interface To use the closest interface, use the no neighbor {ip-address | peer-group-name} update-source interface command. Parameters ip-address peer-group-name interface Enter the IP address of the peer router in dotted decimal format. Enter the name of the peer group to disable all routers within the peer group. Enter the keyword loopback followed by a number of the loopback interface. Range: 0 to 16383. Defaults Not configured. Command Modes ROUTER BGP Usage Information Loopback interfaces are up constantly and the BGP session may need one interface constantly up to stabilize the session. The neighbor update-source command is not necessary for directly connected internal BGP sessions. Command History Version 8.3.3.1 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S60. Introduced support on S-Series Introduced support on C-Series neighbor weight c e s Assign a weight to the neighbor connection, which is used to determine the best path. Syntax neighbor {ip-address | peer-group-name} weight weight To remove a weight value, use the no neighbor {ip-address | peer-group-name} weight command. Parameters ip-address peer-group-name weight Enter the IP address of the peer router in dotted decimal format. Enter the name of the peer group to disable all routers within the peer group. Enter a number as the weight. Range: 0 to 65535 Default: 0 Defaults 0 Command Modes ROUTER BGP 304 | Border Gateway Protocol IPv4(BGPv4)