Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 247

set metric-type c e s Configure a filter to assign a new route type for routes redistributed to OSPF. Syntax set metric-type {internal | external | type-1 | type-2} To delete a setting, enter no set metric-type. Parameters internal external type-1 type-2 Enter the keyword internal to assign the Interior Gateway Protocol metric of the next hop as the route's BGP MULTI_EXIT_DES (MED) value. Enter the keyword external to assign the IS-IS external metric. Enter the keyword type-1 to assign the OSPF Type 1 metric. Enter the keyword type-2 to assign the OSPF Type 2 metric. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.3.3.1 Version 8.3.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S60. Implemented internal keyword Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series Related Commands set automatic-tag set level set metric set tag Compute the tag value of the route. Specify the OSPF area for route redistribution. Specify the metric value assigned to redistributed routes. Specify the tag assigned to redistributed routes. set next-hop c e s Configure a filter to specify an IP address as the next hop. Syntax set next-hop ip-address To delete the setting, use the no set next-hop ip-address command. Parameters ip-address Specify an IP address in dotted decimal format. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.6.1.0 Introduced on the S60. Introduced on E-Series ExaScale Support added for S-Series Access Control Lists (ACL) | 247