Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 490
speed Management interface, stack-unit module - 10g module
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 490 highlights
www.dell.com | support.dell.com speed (Management interface) c e Set the speed for the Management interface. Syntax speed {10 | 100 | auto} To return to the default setting, use the no speed {10 | 100} command. Parameters 10 100 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Enter the keyword 100 to set the interface's speed to 100 Mb/s. Enter the keyword auto to set the interface to auto-negotiate its speed. Defaults auto Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on C-Series Introduced for E-Series Usage This command is found on the Management interface only. Information Related Commands interface ManagementEthernet duplex (Management) management route Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. stack-unit module s Pre-configure ports on 10G optical modules in optional slots to preserve configuration. Syntax Parameters stack-unit {stack-unit id} module {module id} stack-unit id module id Enter the unit number of the stacked unit. Range: 0 - 11 Enter the module id number of the optional slot. Range: 0 - 1 Defaults None Command Modes Configuration Command History Version 8.3.3.7 Introduced on S-Series S60 490 | Interfaces