Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 452
Interface Range prompt with Multiple Ports, Interface Range prompt Overlapping Port Ranges
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 452 highlights
www.dell.com | support.dell.com Example • The interface range prompt includes interface types with slot/port information for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds 32 characters, it is represented by an ellipsis ( ... ). • When the interface range prompt has multiple port ranges, the smaller port range is excluded from the prompt (Figure 15-10). • If overlapping port ranges are specified, the port range is extended to the smallest start port and the biggest end port (Figure 15-11). Figure 15-9. Bulk Configuration Warning Message Force10(conf)#interface range so 2/0 - 1 , te 10/0 , gi 3/0 , fa 0/0 % Warning: Non-existing ports (not configured) are ignored by interface-range Example Figure 15-10. Interface Range prompt with Multiple Ports Force10(conf)#interface range gi 2/0 - 23 , gi 2/1 - 10 Force10(conf-if-range-gi-2/0-23# Example Figure 15-11. Interface Range prompt Overlapping Port Ranges Force10(conf)#interface range gi 2/1 - 11 , gi 2/1 - 23 Force10(conf-if-range-gi-2/1-23# Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel commands can be used in the interface range command. Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-channel interfaces that are not displayed in the show running-config command can not be used with the bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN, Port-channel) using the interface range command. Note: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands related to physical interfaces can be bulk configured. To configure commands specific to VLAN, port-channel or SONET, only those respective interfaces should be configured in a particular range. Example Figure 15-12 is an example of a single range bulk configuration. Figure 15-12. Single Range Bulk Configuration Force10(config)# interface range gigabitethernet 5/1 - 23 Force10(config-if-range)# no shutdown Force10(config-if-range)# 452 | Interfaces