Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 218
Command Example, Defaults, Command Modes, Command, History, Usage, Information, Example
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
www.dell.com | support.dell.com Defaults Not configured Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S60. Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Support added for C-Series Introduced for E-Series Usage Information FTOS supports one ingress and one egress MAC ACL per interface. Prior to 7.8.1.0, names are up to 16 characters long. The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation for detailed specification on entries allowed per ACL. C-Series and S-Series support ingress ACLs only. Example Figure 7-7. Command Example: mac-access-list standard Force10(conf)#mac-access-list access-list standard TestMAC Force10(config-std-macl)#? deny Specify packets to reject description List description exit Exit from access-list configuration mode no Negate a command or set its defaults permit Specify packets to forward remark Specify access-list entry remark seq Sequence numbers show Show Standard ACL configuration permit c e s Configure a filter to forward packets from a specific source MAC address. Syntax permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {any | mac-source-address mac-source-address-mask} command. Parameters any mac-source-address mac-source-address-mask Enter the keyword any to forward all packets received with a MAC address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). 218 | Access Control Lists (ACL)