Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 448
interface Command Example, interface, GigabitEthernet, sonet
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 448 highlights
www.dell.com | support.dell.com interface c e s Configure a physical interface on the switch. Syntax interface interface Parameters interface Enter one of the following keywords and slot/port or number information: • For 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For SONET interfaces, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on the S60. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Example Figure 15-5. interface Command Example Force10(conf)#interface gig 0/0 Force10(conf-if-gi-0/0)#exit# Usage Information Related Commands You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface's configuration does not contain an IP address and enter the switchport command. interface loopback interface null interface port-channel interface sonet interface vlan show interfaces Configure a Loopback interface. Configure a Null interface. Configure a port channel. Configure a SONET interface. Configure a VLAN. Display interface configuration. 448 | Interfaces