Intel S7000FC4UR Product Guide - Page 103

6 Technician Maintenance Note: This chapter describes procedures that require internal server access. You must be a qualified service configuration technician to perform procedures listed in this chapter. To perform these procedures power down the server and remove all power cords from the server. Before You Begin Before working with your server product, pay close attention to the "Safety Information" on page iii. Use the equipment log to record the model and serial numbers of the server and all installed options. Tools and Supplies Needed • Phillips* (cross-head) screwdriver, #2 bit • Phillips screwdriver, #1 bit if installing the RAID battery backup unit • Flat-head screwdriver • Antistatic wrist strap and conductive foam pad (recommended) System References Unless otherwise noted, all references to left, right, front, top, and bottom assume you are facing the front of the chassis as it would be positioned for normal operation. 85