Intel S7000FC4UR Product Guide - Page 45

Label F Name Circuit breaker Location J6F1 Default Empty Stuff Stuffed Jumper State 1 - 2 = 20A/110V (USA) 2 - 3 = 15A/100V (Japan) Figure 15. Main Board Jumpers SATA Device Support The ESB2 provides six Serial ATA (SATA) ports with a transfer rate of up to 3.0GB/s. The main board has two internal, industry-standard 7-pin vertical SATA connectors that can be cabled directly to a SATA device. As an alternative to using a SAS riser to support eight SAS hard drives, an internal x4 8086 SAS/SATA connector is provided to cable to the SAS backplane board to support four SATA hard drives. SATA cables should be 1 meter (40 inches) or less in length. The ESB2 Port configuration is: • SATA0 to SATA connector1 goes to the SATA-to-PATA converter board, then to the optical drive • SATA1 to x4 connector Port0 goes to SATA Drive 0 on the SAS backplane board • SATA2 to x4 connector Port1 goes to SATA Drive 1 on the SAS backplane board • SATA3 to x4 connector Port2 goes to SATA Drive 2 on the SAS backplane board • SATA4 to x4 connector Port3 goes to SATA Drive 3 on the SAS backplane board • SATA5 to SATA connector2 is an extra port that could be used for a SATA tape drive Intel® Server System S7000FC4UR Product Guide 27