Intel S7000FC4UR Product Guide - Page 136
Installing and Removing the I/O Riser Board, Installing the I/O Riser Board
UPC - 735858194259
View all Intel S7000FC4UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Installing and Removing the I/O Riser Board Installing the I/O Riser Board 1. Remove the top cover. For instructions, see "Removing the Top Cover" on page 90. 2. Being careful not to touch the components or connectors on the I/O riser card, remove the card from the anti-static bag and place it on a clean, ESD-protected work surface. 3. Optional: Install the Intel® Remote Management Module 2 (Intel® RMM2) and RMM2 NIC onto the I/O riser board. For instructions, see "Installing the Intel® RMM2 and NIC Module" on page 119. 4. Rotate the retention latch at the rear of the card slot into the up position. 5. If an expansion slot cover is installed, remove it by sliding it up. 6. Press the card down firmly until it seats into the slot. 7. Install the top cover. For instructions, see "Installing the Top Cover" on page 91. Removing the I/O Riser Board 1. Remove the top cover. For instructions, see "Removing the Top Cover" on page 90. 2. Optional: Remove the Intel® Remote Management Module 2 (Intel® RMM2) and RMM2 NIC from the I/O riser board if they are installed. For instructions, see "Removing the Intel® RMM2 and NIC Module" on page 121. 3. Rotate the retention latch at the rear of the card slot into the up position. See letter "A" in the following figure. 4. Installed an expansion slot cover by sliding it down to cover the opening. 5. Press the card down firmly until it seats into the slot. 6. Install the top cover. For instructions, see "Installing the Top Cover" on page 91. 118 Intel® Server System S7000FC4UR Product Guide