Intel S7000FC4UR Product Guide - Page 137
Installing and Removing the Intel® Remote Management Module 2 (Intel® RMM2)
UPC - 735858194259
View all Intel S7000FC4UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Installing and Removing the Intel® Remote Management Module 2 (Intel® RMM2) The optional Intel® RMM2 comes as a kit with these contents: • One Intel® Remote Management Module 2 with one plastic standoff pre-installed • One network interface card (NIC) module • One plastic bag of screws, a slot bracket, cabling, and three plastic standoffs (these standoffs are not used for this installation) Installing the Intel® RMM2 and NIC Module 1. Remove the top cover. For instructions, see "Removing the Top Cover" on page 90. 2. Remove the I/O riser card. For instructions, see "Removing the I/O Riser Board" on page 118. 3. Set the I/O riser card on a static-controlled surface with the components facing up. 4. Write down the MAC address on the Intel® RMM2. It is on a label attached to the Intel® RMM2. If you do not write down the MAC address before installing the Intel® RMM2, you will need to open the system later to record this information before you can configure the Intel® RMM2. Note: The I/O gasket is required to meet EMI requirements. 5. Peel the backing from the EMI gasket that is included with your Intel® Remote Management Module 2 kit. See letter "A" in the following figure. 6. Adhere the EMI gasket to the I/O riser board where the NIC will contact the I/O riser. See letter "B" in the figure. Intel® Server System S7000FC4UR Product Guide 119