Intel S7000FC4UR Product Guide - Page 89
Removing a Hot-swap PCI Card, Hardware Interface
UPC - 735858194259
View all Intel S7000FC4UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Removing a Hot-swap PCI Card, Hardware Interface Caution: Only PCI add-in cards in PCI slots 1 and 2 can be hot-swapped. If you are adding or removing a PCI card from PCI slots 3 through 7, see "Removing a Non-hot-swap PCI Card" on page 74. When looking at the system from the front, slots 1 and 2 are at the right. 1. Remove the top cover. For instructions, see "Removing the Top Cover" on page 58. 2. Press the attention button for the slot. See the following figure. Note: Press the attention button again within five seconds to abort the hot-plug operation. AF002268 Figure 36. PCI Slot Attention Button 3. Wait for the power LED on the slot to turn off. 4. Disconnect any cables to the PCI card. 5. Rotate the retention latch at the rear of the card slot into the up position. See letter "A" in Figure 35 on page 70. 6. If a full-length card is installed, press the blue plastic piece at the front of the card. 7. Pull up on the card to remove it. 8. Store the card in an anti-static bag. 9. Install an expansion slot cover over the empty slot or install a replacement PCI card: Intel® Server System S7000FC4UR Product Guide 71