Kyocera KM-6030 6030/8030 Operation Guide (Advanced Edition) Rev-3 - Page 52
Backing Sheets for Transparencies, Copying on Backing Sheets, Blank Backing Sheets - electrical
View all Kyocera KM-6030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Copying Functions Backing Sheets for Transparencies When two or three transparencies are stacked on top of each other, static electricity may make them difficult to handle. This mode automatically inserts a backing sheet between transparencies for easier handling. You can copy the same image onto the backing sheet or make multiple copies from the original. NOTE: Always use the MP tray when copying onto transparencies. When the backing sheets for transparencies mode is selected, the paper type specified to the MP tray is automatically changed to [Transparency]. When installing the optional document finisher, you may need to specify the output destination for finished copies. For instructions, refer to Selecting Output Destination on page 3-29. Copying on Backing Sheets Copies the same image as the transparency onto the backing sheet. (In the figure, the asterisk indicates transparencies.) 1 2 3 1* 1 2* 2 3* 3 Originals Copies Blank Backing Sheets Supplies a blank backing sheet after copying to a transparency. (In the figure, the asterisk indicates transparencies.) 1 2 3 1* 2* 3* Originals Copies Follow the steps as below to produce backing sheets for transparencies. 1 Place the originals in the document processor or on the platen. 2 Load transparencies in the MP tray. IMPORTANT: Fan through the transparencies before loading them. Up to 25 transparencies can be loaded at one time. Be sure that paper of the same size and orientation as the transparencies is loaded. 3 Press [Function] and then [T Down]. 1-46