Lexmark C750 Service Manual - Page 102
Lexmark C750 Manual
View all Lexmark C750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
5060-00x S2 sensor late • 2D 11-S2 sensor late • 2D 03-S2 sensor late Note: See "Printer sensors" on page 5-3. Step 1 Action and questions Check the tray for proper edge guide setting and media loading. Edge guides should be adjusted against edge of media. Media should be fanned and lay flat in the tray. Is the media properly loaded in the tray? 2 Check the pick tires for contamination or wear. Are pick tires worn or contaminated? Replace the pick tires. See "Pick rolls" on page 4-48. Clear the obstruction. Correct the deflector position. Go to"Autocompensa tor service check" on page 2-114 Call your next level of support. Go to step 3 Yes Go to step 2 No Properly load media. 3 Check for obstructions in the paper path. Is the paper path obstructed? Go to step 4 4 5 Is the inner deflector out of position? Is the autocompensator damaged or defective? Go to step 5 Go to step 6 6 Perform the "BASE SENSOR TEST" on page 3-29 on the S2 sensor. Does the S2 sensor pass the test? See "S2 or narrow media sensor obstructed" on page 2-67. S2 or narrow media sensor made early • 2D 0F-S2 sensor early • 2D 02-S2 sensor early • 2D 05-Narrow media sensor early Note: See "Printer sensors" on page 5-3. Step 1 Action and questions Check tray for the edge guide setting and media loading. Edge guides should be adjusted against edge of media. Media should be fanned and lay flat in the tray. Is the media properly loaded in the tray? 2 Media may not have been cleared from a previous jam. Is media in paper path? Clear the paper path. Call your next level of support Yes Go to step 2 No Properly load media. 2-68 Service Manual