Lexmark C750 Service Manual - Page 136
Lexmark C750 Manual
View all Lexmark C750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
5060-00x 500-sheet drawer For 990 Service Error - Tray x, x=Tray 2, 3, 4 or 5, this is the tray that has a problem or needs service. Note: Verify the autoconnect housing is correctly snapped into the printer and all options, and is plugged into the system board correctly. Step 1 Action and questions Make sure the autocompensator cable is correctly installed at the tray System board. Is the cable correctly installed? 2 Make sure the drive assembly cable is connected correctly to the tray system board. Is the cable correctly installed? 3 Check for worn or broken parts in the autocompensator and drive assemblies. Are any parts worn, broken, or damaged? Replace the assembly that has the defective parts Replace the FRUs in the following order: 1. Electronic/ size sensing assembly 2. Autocompensator assembly 3. Drive assembly Go to step 3 Install the cable correctly Yes Go to step 2 No Install the cable correctly Output expander Step 1 Actions and questions Mechanical linkage/DC motor assembly-check the DC motor cable connector to make sure it is installed at J4 on the output expander control board. Is the cable connected correctly? 2 Resistance check-disconnect J4 from the option board and check the resistance of the motor on the cable connector between J4-1 and J4-2. The resistance should measure between 115 and 135 ohms. Is the resistance correct? 3 DC Motor-check between J4-1 and between J4-2 and the case of the DC motor for shorts. Is the DC motor shorted? Note: If the DC motor is found to be shorted damage may result to the RIP board. Replace the mechanical linkage/DC motor assembly Go to step 4 Go to step 3 Yes Go to step 2 No Reseat the cable and recheck for correct operation of the option Replace the mechanical linkage/DC motor assembly 2-102 Service Manual