Lexmark C750 Service Manual - Page 454
Lexmark C750 Manual
View all Lexmark C750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 454 highlights
5060-00x Step 5: Connect the finisher and printer Push the finisher against the printer, making sure the gap in the front is the same as the gap in the back. When adjoining the finisher and the printer, make sure that the finisher cable is out of the way of the paper path. If the cable folds itself between the finisher and the printer, disconnect the cable, twist it one time, and then reconnect it. This may help the cable bend the other direction. Finisher alignment quick check Use this table to make sure all alignments have been made. Make sure: 1. The printer is secured to the floor. 2. The finisher's height is correct. The pin should align with the hole in the finisher, and the finisher should easily dock to the printer without interference or binding with the pin. To make adjustments, see: "Step 1: Secure the printer" on appendix page A-24 "Step 2: Align the pin" on appendix page A-25 3. The finisher is vertically aligned to the printer. "Step 3: Align the bumper pads" on appendix The finisher's two bumper pads should lightly touch the printer. page A-26 4. The finisher's tilt is correct. The printer and finisher's front covers should be flush together at top and bottom. If you run your hand across them from side to side they should feel as if they are one part. 5. The finisher is squarely docked to the printer. The printer and finisher's top covers should have the same distance between them at the front and rear when docked. "Step 4: Adjust the tilt" on appendix page A-27 "Step 5: Connect the finisher and printer" on appendix page A-28 A-28 Service Manual