Lexmark C750 Service Manual - Page 64

5060-00x User primary message 272 Paper Jam Clear Paper Path User secondary message Leave Job in Finisher area 5 Explanation Primary: Media is jammed in the 5-bin mailbox option. Open the rear door of option to access the jammed media. Secondary: If sheets have been accumulated to be stapled when the jam is detected, the printer alternately flashes the primary and secondary messages indicating the accumulated sheets should not be removed during jam clearing. Note: When the secondary message is displayed, if the accumulated sheets are removed the printer will not reprint these sheets. Also if the print job is completed, the portion of the job printed after the jam will not be stapled. 280 Paper Jam Clear Paper Path Leave sheets in Finisher area 5 Primary: Media has jammed in the finisher option. Open the finisher side door to top cover to access the jammed pages. Secondary: If sheets have been accumulated to be stapled when the jam is detected, the printer alternately flashes the primary and secondary messages indicating the accumulated sheets should not be removed during jam clearing. Note: When the secondary message is displayed, if the accumulated sheets are removed the printer will not reprint these sheets. Also if the print job is completed, the portion of the job printed after the jam will not be stapled. 282 Staple Jam Check Stapler 283 Staple Jam Check Stapler Remove Job from Finisher These messages are displayed when the stapler device detects a paper jam. 282 Staple Jam indicates that a staple jam has been detected during normal stapler operation such as when printing and stapling jobs. 283 Staple Jam indicates that a staple jam has been detected during a priming operation. No secondary message will be displayed. Note: After the error has been cleared, the printer does not reprint any pages which existed in the accumulator for stapling. The following actions can be taken while either the primary or secondary messages are displayed: Press Go to initiate priming and resume printing. Note: Use of the "Sub error code table" on page 2-17 may help in diagnosing 282 and 283 Errors. Setup Required This message is displayed when the printer has detected at POST, that packing material is still installed and must be removed. The user should verify that the machine is properly setup. Press Go and Reflash Code. A Alignment =x.x* This message is displayed when an ITU Alignment Procedure is in process and the printer is prompting the user for the x (x=A through L) alignment value. Alignment values for A through L (=x.x*) -7 to +7 in 0.5 increments. • Enter the alignment value and press Select to continue to the next alignment value. • To abort the alignment operation press Go or Return. 2-30 Service Manual