Lexmark C750 Service Manual - Page 220
Lexmark C750 Manual
View all Lexmark C750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
5060-00x Screw identification table The following table contains screw types, locations, and quantities necessary to service the printer. Pay careful attention to each screw type location when doing removals. You must install the correct screw type in each location during reassembly. Reference number 002 Screw type 4-40 machine Location Parallel connector to shield Purpose Attach Qty 2 102 M3.5x8mm thread cutting Cartridge guides to upper frame Upper front cover to cartridge guides Front cover pivot to front upper cover Front left light shield to upper front cover Attach Attach Attach Attach 8 4 2 1 121 M3.5x6mm machine LVPS to lower frame Right rear cover to LVPS HVPS standoffs to upper frame Mounting Attach Attach 7 1 4 232 M3x6mm Taptite metal thread forming Ground cable to right front cover support and upper frame. Ground cable to bottom support plate and engine card shield Back lamp brackets to fuser frame Front lamp brackets to fuser frame Blank INA covers to RIP shield RIP card ground shield to RIP shield RIP shield to engine shield RIP card to RIP shield Engine card to engine shield RIP shield cover to RIP shield V-block plates to upper frame Ground cable strap to RIP ground shield Attach Attach Attach Attach Mounting Mounting Mounting Mounting Mounting Mounting Mounting Attach 2 2 2 2 2 5 4 12 6 8 2 1 4-2 Service Manual