Lexmark C750 Service Manual - Page 453

5060-00x Short and tall finisher 1. Lift the platform cover. 2. Insert the Allen wrench (D) into either caster bolt (J). 3. Rotate the wrench in the appropriate direction to adjust the height of the finisher (clockwise raises the finisher). 4. Repeat with the other caster bolt. Step 4: Adjust the tilt If necessary, adjust the tilt of the finisher so that the front is flush with the front of the printer. This can usually be done by adjusting the two front casters (those closest to the finisher door). Note: When adjusting the tilt, be sure that the adjustments made in steps 1 and 2 are maintained. Additional adjustments may be necessary in those locations. If the finisher wobbles after making adjustments in steps 1, 2, and 3, make sure each caster touches the floor. Appendix A-Service tips A-27