Lexmark C750 Service Manual - Page 71

5060-00x User primary message 37 Insufficient Memory User secondary message Held Jobs May Not Be Restored Explanation These messages are displayed when the printer has attempted to print and hold jobs from the disk and found that some or all of the jobs could not be restored. Each of the three 57 Configuration Held Jobs messages describe different conditions under which the restore failed. • Primary Message: 37 Insufficient Memory. The printer firmware ran out of memory while attempting to restore the jobs. Secondary Message: Held Jobs May Not Be Restored. • Primary Message: 57 Configuration Change-the printer firmware could not restore jobs from the disk because the configuration of the printer has changed. Secondary Message: Held Jobs May Not Be Restored. • Primary Message: Held Jobs May Not Be Restored handles any other conditions where any of the print and hold jobs could not be restored from the disk. Note: Some of the print and hold jobs may not be restored. They remain on the disk but cannot be accessed. 38 Memory Full This message is displayed when the printer is processing an incoming job and there is not enough memory available to continue processing the job. The following actions can be taken: You may want to determine how to make more memory available to your print job by: Deleting fonts, macros and other data in RAM Simplify your print job Install additional memory Press Go to clear the message, however some data may be lost • Press Menu to access the Busy/Waiting Menu The following functions may be available. • Cancel Job • Reset Printer • Reset Active Bin • Check Supply Levels Note: Menu Lockout does NOT prevent access to the Busy/ Waiting Menu 39 Complex Page This message is displayed when a page is too complex to print. The following actions can be taken: • Press Go to clear the message and continue processing the job, some data loss may occur. • Try to simply the print job Press Menu> to access the Busy/Waiting Menu. The following functions may be available: • Cancel Job • Reset Printer • Reset Active Bin • Check Supply Levels Note: Menu Lockout does NOT prevent access to the Busy/ Waiting Menu. Diagnostic information 2-37