Lexmark C750 Service Manual - Page 66
Lexmark C750 Manual
View all Lexmark C750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
5060-00x User primary message Reattach Output Bin x Reattach Bins x-y Check Tray x Connection User secondary message Explanation These messages are displayed anytime the printer loses communications with one of the following options Output Bin x (x=1, 2, or 3) Bins (x-y=1 through 5) Tray x (x=2, 3, 4, or 5) Duplex Finisher Check Duplex Connection Check Finisher Connection The specified option could have been removed from the printer, maybe to clear a paper jam or to uninstall the option or the option may be still installed but experiencing a communications problem. The option may not be fully installed or it may have a hardware failure. The most likely cause of this message is a failure to reattach the option when removed to service a printer intervention. If the option was temporarily removed or not connected properly, then reattach or reconnect it. When the option is recognized, the printer automatically clears the attendance message and continues. Press Go to execute a configuration change which will tell the printer the option has been Hot Unplugged removed. In this case it is assumed that the user wants to continue to operate the printer with the option removed. If the problem continues, turn the printer off and back on. If the message continues to be displayed, turn the printer off, remove the option and call for service. Close Door This message is displayed when the printer upper front cover (door) is open. Close the upper front cover (door). Close Finisher Door Disk Corrupted This message is displayed when the finisher Option top cover is open. Close the finisher top cover. This message is displayed when the printer has detected that there are errors on the hard disk that could not be corrected. The disk cannot be used until it has been reformatted. The following actions can be taken: • Press Return or Stop to clear the message. The disk cannot be used without reformatting the disk. Note: All data will be lost for the following action: • Press Go to format the disk. Hole Punch Waste Full This message is displayed when the Hole Punch Alarm is on and the code has determined that the hole punch waste box is full. The following actions may be taken while this message is displayed: • The user may empty the hole punch box and put it back to clear the message. • Press Go to ignore the message and the job prints without hole punching. Each time a new job requests hole punch and the box is not emptied, this message is displayed. 2-32 Service Manual