3Com 3C63311 Reference Guide - Page 121
Data Rate, Min. Flag Bytes, FCS Size, Admin. Status
View all 3Com 3C63311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Configuring the Serial Interface 109 Data Rate-The data rate supported by the port: 48K, 97K, 195K, 390K, 781K, 1.5M, 3.1M, or 6.2M. This parameter applies only when the attached cable is DCE type cable. It is a very important parameter, as it allows you to direct the SIM to shape particular data applications so as not to exceed the guaranteed bandwidth established by your service provider in your service contract. The Data Rate setting also allows you to optimize the entire WAN ATM application by traffic engineering your ATM access applications so as to maintain traffic flow across the network. Min. Flag Bytes-The minimum number of flag bytes required to distinguish a frame: 1, 2, 4, 6, 8, 10, 12, or 14. FCS Size-The number of bytes to use for FCS (Frame Check Sequence) calculation for each frame. FCS is the CRC remainder sent at the end of a frame. This parameter is valid only for HDLC/SDLC data. Admin. Status-Administrative status: Out of Service or In Service. 6 Select [8] Previous Menu to return to the SIM Port Configuration Port/LMI Selection menu, shown earlier in Figure 77. 7 If desired, selected [2] LMI Configuration to display the SIM LMI Configuration menu, shown in Figure 79. This menu allows you to set the protocol for the local management interface. You can set the LMI protocol only if the Link Type is set to Frame Relay on the SIM Port Configuration menu. If the Link Type is set to DXI or SDLC, the LMI Configuration option does not appear on the SIM Port Configuration Port/LMI selection menu, shown earlier in Figure 76. Figure 79 SIM LMI Configuration Menu 8 Select [1] Set Protocol. The following prompt appears at the bottom of the screen: (1 = none, 2 = q.933a, 3 = t1.617d) 9 Enter the number corresponding to the desired protocol or 1 for no LMI.