3Com 3C63311 Reference Guide - Page 129

Configuring the Ethernet Interface 117 To configure source address filtering, follow these steps: 1 From the Bridge menu, select [3] Source Address Filtering to display the Source Address Filter menu, shown in Figure 89. Figure 89 Source Address Filter Menu 2 Select [2] Add Source Filter Address. The Add Source Address Filter screen appears. This screen displays the following prompt: Enter MAC Address (XX:XX:XX:XX:XX:XX or ): 3 Enter the MAC address of the station from which you do not want packets to traverse the bridge. After you make your entry, you are returned to the Source Address Filter menu. 4 Repeat steps 2 and 3, as desired, to add more addresses to the source filter list. n To view the current list, select [1] List Source Filter Address from the Source Filter Address menu. n To change an address in the list, delete the incorrect address and add the correct address. n To delete an address from the list, select [3] Delete Source Filter Address from the Source Filter Address menu and enter the number corresponding to the address you want to delete. Then enter y at the confirmation prompt to delete the selected address. 5 Select [4] Previous Menu to return to the Bridge menu 6 Select [1] Setup to display the Bridge Setup menu, shown earlier in Figure 88. This menu allows you to enable or disable the filters you have configured. 7 Select [2] Set Source Address Filtering. The following prompt appears at the bottom of the screen: Enter Source Address Filter (1=Disable, 2=Enable) 8 Enter 2 to enable the source address filter.