3Com 3C63311 Reference Guide - Page 67
Inservice green, ALARM red, Connecting to the Voice Compression Module, CBR Module LEDs
View all 3Com 3C63311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Installation Procedures 55 CBR Module LEDs The CBR module features the following front panel indicators: Inservice (green)-Powers up in the "off" state and illuminates when you set the administrative status of the T1-DSX/E1 or serial port to In Service. See "Configuring the CBR Module" in Chapter 4 for details about how to set the administrative status of the ports on the CBR module. ALARM (red)-Powers up in the "off" state and illuminates when an alarm condition is detected on the corresponding T1-DSX/E1 or V.35 line. Figure 25 PathBuilder S330 CBR Module LEDs Alarm Inservice T1-DSX/E1 ports Serial (RS-366 and V.35/RS-449/ RS-530/X.21) port Connecting to the Voice Compression Module The Voice Compression module provides an RJ48 DSX interface for T1-DSX/E1 traffic. Line Build Outs (LBOs) to DSX of up to 655 feet are supported. You must configure the LBOs in the VCM Port Configuration Menu. See "Configuring the Voice Compression Module" in Chapter 4, for details. You can typically make local connections to DTE equipment without DSU/CSUs, as long as the equipment supports a direct T1-DSX/E1 interface and can recover a T1-DSX/E1 signal. Table 21 lists the VCM T1-DSX pinouts. Table 21 VCM T1-DSX/E1 Pinouts PIN 1 PIN 2 PIN 3 PIN 4 PIN 5 PIN 6 PIN 7 PIN 8 RX (ring) RX (tip) NC TX (ring) TX (tip) NC NC NC If you are using a G703 coax physical connection to connect the E1 line to the interface, you must use the E1 Balun Adapter (part number 3C63904).