3Com 3C63311 Reference Guide - Page 85
Shaper Number, IP Address, Subnet Mask, VPI/VCI
View all 3Com 3C63311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Figure 45 Add Virtual Circuit Menu Configuring In-band Management 73 3 Build a PVC on the far-end PathBuilder S330/S310, using the MCPU as side A of the circuit. Set the following parameters on the Add Virtual Circuit screen: n Shaper Number-Choose the number corresponding to the desired shaper value. You assign the shaper number from the MCPU Shapers screen. See "Configuring MCPU Shapers" in Chapter 4, for details. n IP Address-You must use a different subnet than the one you used for the near-end PathBuilder S330/S310. n Subnet Mask-Specify any acceptable address (for example, 255.255.255.0) n VPI/VCI-You must use the same values as you did for the near-end PathBuilder S330/S310. 4 On the Manage IP Network Configuration menu, select [3] Default Gateway Configuration and set the following: a Set the default gateway on the far-end PathBuilder S330/S310 to the PVC IP address you set for the near-end PathBuilder S330/S310 in step 1. b Set the default gateway on the management station to the local host IP address of the near-end PathBuilder S330/S310. For details about setting the default gateway, see "Configuring the Default Gateway" earlier in this chapter. 5 Apply your IP configuration changes. a From the main menu, select [1] System Administration. b From the System Administration menu, select [3] Manage IP Network Configuration. c From the Manage IP Network Configuration menu, select [1] Local Host IP Configuration. d From the Local Host IP Configuration menu, select [2] Apply IP Configuration Changes.