3Com 3C63311 Reference Guide - Page 158
bottom of the screen
View all 3Com 3C63311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
146 CHAPTER 4: CONFIGURING PATHBUILDER S330/S310 MODULES, PORTS, AND APPLICATIONS Figure 116 Configuring Side A of A VCM VCC Virtual Circuit When you have entered a setting for each parameter, the Add Virtual Screen again displays the list of PathBuilder S330/S310 modules and ports by slot number and prompts you to enter a slot number for side B of the circuit, as shown in Figure 117. Figure 117 VCM VCC Add Virtual Circuit Screen with Side A Completed 4 Select the slot number corresponding to the module by which you are connected to the network for side B of the circuit. 5 Repeat steps 3and 4 for side B of the circuit. The following prompt appears at the bottom of the screen: Is the above information correct (y/n)? 6 Enter y to confirm your configuration. Figure 118 shows a completed VCM VCC circuit. As shown in the figure, the following message appears at the bottom of the screen: VC has been added. Press any key to continue.