Dell 1815dn User's Guide - Page 140

Add Paper & Press Start Invalid Cartridge Connection Error COMM. Error Retry Data Read Fail Check USB key Data Write Fail Check USB key Document Jam Check Feeder Door Open Front Door Duplex jam 0 Check Inside Duplex jam 1 Check Inside Enter Again File Format Not Supported Fuser Door Open Group Not Available Hsync Error JAM 2 OPEN REAR & FRONT DOOR Job cancelled by user Job limit (15) reached Junk Fax Job Cancelled Line Busy Try Later Line Error Retry Low Heat Error Cycle Power Once Mail Excceds Server Support Memory Full Cancel or Start Memory Full Divide the Job Network Error No Answer Try Later The bypass tray is empty in the manual feeder mode. The toner cartridge you have installed is not for your printer. Connection with the SMTP server failed. The printer has a communication problem. Delete the number after the delayed fax job is sent. Load a sheet of print material and press Start ( ). You need to press the button each page to be printed. Install a Dell-genuine toner cartridge, designed for your printer. Check the server settings and the network cable. Ask the sender to try again. Time expired while reading data. Try again. Storing to the USB memory key failed. Check the available USB memory space. The loaded document has jammed in the ADF. Clear the document jam. See "Clearing Jams in the ADF". The front cover is not securely latched. Close the cover until it locks into place. Paper has jammed during duplex printing. Clear the jam. See "Duplex Jam 0". Paper has jammed during duplex printing. Clear the jam. See "Duplex Jam 1". You entered an unavailable item. The selected file format is not suppoted . Enter the correct item again. Use the correct file format. The fuser door is not securely latched. Open the rear cover and close the fuser door until it locks into place. For the location of the fuser door, see "Paper Exit Jam". You have tried to select a group location number where Use a speed dial number or dial the number manually only a single location number can be used, such as when using the number keypad. adding locations for a broadcasting operation. A problem has occurred in the Laser Scanning Unit (LSU). Unplug the power cord and plug it back in. If the problem persists, call for service. Paper has jammed in the paper exit area. Clear the jam. See "Paper Exit Jam". Cancel ( ) is pressed during transmission. Try again after a few minutes. The number of jobs stored in the printer is 15 and you are trying to add 16th job. Delete jobs in the printer or try later after completing some jobs. The received fax number is the number stored in memory Change the Junk Fax Setup option. as junk fax number. The receiving party did not answer or the line is already Try again after a few minutes. engaged. Your printer cannot connect with a remote printer or has Try again. If the problem persists, wait for an hour or try a lost contact because of a problem with the phone line. different phone line if possible and then try to connect again. There is a problem in the fuser unit. Or, turn the ECM mode on. See "ECM Mode". Unplug the power cord and plug it back in. If the problem persists, call for service. The mail size is larger than the supported size by SMTP Divide your mail or reduce the resolution. server. The memory is full. Delete unnecessary documents, retransmit after more memory becomes available. The memory is full. Split the transmission into more than one operation. There is a problem with the network. Contact your network administrator. The remote fax machine has not answered after several Try again. Verify the number to make sure a fax can be redial attempts. received.