Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1071

Command Mode Global Configuration User Guidelines Use this command to globally configure the format of MAC addresses sent in the Original-Called-Number (30), Calling-Station-Id (31), or NAS-Identifier (32) attributes for ports configured for 802.1x authentication or MAB. This command is only supported for 802.1X and MAB authentication. Local authentication formats are not configurable. This command does not override the per RADIUS server configuration. Use the mab request format command to configure formatting the User-Name attribute. Use the attribute mac format command in RADIUS Server Configuration mode to configure the MAC format for an individual RADIUS server. Command History Introduced in version 6.3.0.1 firmware. Updated in release 6.5.0 to remove formatting of the User-Name attribute. Updated in release 6.6.0 to add formatting of attributes 30 and 31. Example This example globally configures the format of the MAC address sent in the Calling-Station-Id attribute to IETF lower case. It also configures interface Gi1/0/1 to use MAB. For this command to have any affect, MAB must be configured on the switch in an active authentication list, IEEE 802.1X must be configured, and a RADIUS server must also be configured. console(config)#radius server attribute 31 mac format ietf lower-case console(config)#interface gi1/0/1 console(config-if-Gi1/0/1)#authentication host-mode multi-auth console(config-if-Gi1/0/1)#mab radius server attribute 168 Use the radius server attribute 168 include-in-access-req command to enable the switch to send the RADIUS Framed-IPv6-Address attribute in AccessRequest messages sent to the RADIUS authentication server. Security Commands 1071