Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1392

Example The following example shows how to set the extended community attribute for site of origin with route-maps on the sending BGP router. (R1)(Config)# ip extcommunity-list 10 permit (R1)(config)# route-map RECV_IN permit 10 (R1)(config-route-map)# set extcommunity soo 10:10 (R1)(config-route-map)# exit The receiving BGP router will apply the route map with an extended community list in the inward direction. show bgp ipv6 Use this command to display IPv6 routes in the BGP routing table. This command deprecates and replaces the show ipv6 bgp command. Syntax show bgp ipv6 [vrf vrf-name] [ipv6-prefix | prefix-length [longer-prefixes | shorter-prefixes [length]] | filter-list as-path-list] • vrf-name-Displays information about the specified VRF. If no parameter is passed, the information displayed will be for the router in the default VRF. • ipv6-prefix-An IPv6 network prefix. This argument must be in the form where the address is specified in hexadecimal using 16-bit values between 0x00 and 0xff and separated by colons. Limits the output to a specific prefix. • prefix-length-The length of the IPv6 prefix given as part of the ipv6prefix. This is required if a prefix is specified. A decimal value in the range 1 to 128 that indicates how many of the high-order contiguous bits of the address comprise the prefix (the network portion of the address) in /length format. A slash mark must precede the decimal value in /length format. • longer-prefixes-Displays the specified prefix and any longer prefixes within the same range. • shorter-prefixes [length]-Used with the ipv6-prefix/prefix-length option to show routes whose prefix length is shorter than prefix-length, and, optionally, longer than a specified length. This option may not be given if the longer-prefixes option is given. Layer 3 Routing Commands 1392