Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 2420

User Guidelines The show switch command shows the configuration and status of the stacking units, including the active and standby stack management units, the pre-configured model identifier, the plugged in model identifier, the switch status and the current code version. Both the pre-configured switch types (as set by the member command in stack mode) and the currently connected switchtypes, if any, are shown. The show switch stack-member-number command also shows details of the switch configuration including the SFS last attempt status for the specified unit. If there is a stack firmware synchronization (SFS) operation in progress, the switch status will show as Updating Code. The show switch command may show an SDM Mismatch value in the Switch Status field. This value indicates that the unit joined the stack, but is running a different SDM template than the management unit. This status should be temporary; the stack unit should automatically reload using the template running on the stack manager. Use the show supported switchtype command to display switch SIDs. Use the show switch stack-ports command to display details regarding stacking links. Use the show slot command to display details regarding slot configuration. Use the show sdm prefer command to display the SDM template configuration. The show switch stack-ports stack-path command is useful in tracking the path a packet may take when traversing stacking links. The command shows active paths only, not those that may be taken after a stack failover or stack reconvergence. The following table describes the fields in the switch stack status example. Unit Switch Management Status Description This field displays the unit identifier assigned to the switch. This field indicates whether the switch is the Management Switch, a stack member, or the status is unassigned. Switch Management Commands 2420