Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 241

Table 2-1. History Buffer Keyword Up-arrow key + Down-arrow key + Source or Destination Recalls commands in the history buffer, beginning with the most recent command. Repeats the key sequence to recall successively older commands. Returns to more recent commands in the history buffer after recalling commands with the up-arrow key. Repeating the key sequence recalls more recent commands in succession. By default, the history buffer system is enabled, but it can be disabled at any time. The standard number of 10 stored commands can be increased to 216. By configuring 0, the effect is the same as disabling the history buffer system. For information about the command syntax for configuring the command history buffer, see the history size command in the Line command mode section of this guide. Negating Commands For many commands, the prefix keyword no is entered to cancel the effect of a command or reset the configuration to the default value. Nearly all configuration commands have this capability. This guide describes the negation effect for all commands to which it applies. Show Command The show command executes in the User Executive (Exec), Privileged Executive (Exec), Global Configuration mode, Interface Configuration mode and all configuration submodes with command completion. Output from show commands is paginated. Use the terminal length command to set the number of lines displayed in a page. When the paging prompt appears, press the space bar to display the next page of output or the enter key to display the next line of output. Example: console>en console#configure console(config)#interface Gi1/0/1 Using the CLI 241