Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1225

passwords strength minimum special-characters Use this command to enforce a minimum number of special characters that a password may contain. The valid range is 0-16. The default is 1. A setting of 0 means no restriction. Special characters are one of the following characters Use the no form of this command to reset the minimum special characters to the default value. Syntax passwords strength minimum special-characters 0-16 no passwords strength minimum special-characters Default Configuration The default value is 1. Command Mode Global Configuration User Guidelines This limit is not enforced unless the passwords strength minimum specialcharacters command is configured with a value greater than 0. In other words, a configuration of 0 allows a password consisting entirely of special characters to pass strength check validation. Example console(config)#passwords strength minimum special-characters 6 passwords strength max-limit consecutivecharacters Use this command to enforce a maximum number of consecutive characters that a password can contain. If a user enters a password that has more consecutive characters than the configured limit, the system rejects the password. The valid range of consecutive characters is 0-15. The default is 0. A maximum of 0 means there is no restriction on consecutive characters. Security Commands 1225